shadow 6u / 208hp
shadow 6u / 208hp
the shadow case embodies our vision of a slimline airline-friendly eurorack travel case.
great care was taken to maintain a form factor that was slim and lightweight, while making sure the needs of the traveling musician were met.
using modern design, manufacturing techniques, and materials, nearly every aspect has been custom engineered to exacting detail.
aluminum shell
elastomer coated exterior
powder coated interior
high-density polypropylene end panels
custom milled spring-action latches
urethane lid bumpers and feet
total case depth is able to accommodate all but the deepest of modules, and lid depth allows for patches to be kept intact for quick setup time at gigs.
modularity was also a key element to the shadow design. our manifold system allows two fully cross-patched cases to snap together with ease, while still maintaining an airline-friendly form factor. for the studio side of things, a low cost desktop frame will be released that will allow two cases to sit in a stylish, angled, ergonomic, studio friendly vertical arrangement.
the expandability of our system means that it grows as you grow.
while a custom nylon carrying harness is included with each case, the form factor of a single shadow will fit within a variety of third party manufacturer’s 37-key keyboard cases.
all shadow 6u / 208hp cases include:
latching lid
carrying harness
25 sliding nuts in each rail
100 2.5mm stainless steel hex screws
100 nylon washers
hex wrench
recessed power switch
recessed power jack
powered version includes:
make noise powered bus board
1.4a @ +12v
1.4a @ -12v
1a @ +5v
20 power headers
custom power board retainers
2.1mm 5a dc power jack
cincon 4.6a universal power adapter
iec power cable
unpowered version - out-of-the-box ready for the intellijel tps80w:
custom power board retainers
2.5mm 5a dc power jack
forked terminals
**** a special note regarding the intellijel tps80w ****
if you plan on using the unpowered case with an intellijel tps80w board and their recommended power supply you MUST NOT EXCEED 93% (75W) OF DRAW FROM THE EXTERNAL POWER SUPPLY. this is due to the 5a rating on the power jack.
do not exceed the following on each rail:
2790ma +12v
2790ma -12v
1395ma +5v
internal dimensions
527 x 260 x 53mm (l x w x h)
53mm module depth to rear of faceplate
40mm above power board if ordered with power
44mm lid depth
external dimensions incl. lid and feet
556 x 265 x 109mm (l x w x h)
weight
unpowered w/ lid: 7.5lb / 3.4kg
powered w/ lid: 7.9lb / 3.6kg
carrying harness: 6.9oz / 195g